Download PDF
Free download in PDF Building Construction Multiple Choice Questions and Answers for competitive exams. These short objective type questions with answers are very important for Board exams as well as competitive exams. These short solved questions or quizzes are provided by Gkseries.
(1)
As compared to stretcher course, the thickness of joints in header course should be
[A]
Less
[B]
More
[C]
Equal
[D]
Equal or more
(2)
The minimum strength of the mortar used in load bearing brick masonry, is
[A]
50 N/cm2
[B]
100 N/cm2
[C]
150 N/cm2
[D]
200 N/cm2
(3)
In soils possessing low bearing capacity, the type of foundation generally provided, is
[A]
Column footing
[B]
Grillage footing
[C]
Raft footing
[D]
All the above
(4)
The columns of multi-storeyed buildings are designed to withstand the forces due to
[A]
Dead loads
[B]
Live loads
[C]
Wind loads
[D]
All of these
(5)
The number of steps in a flight generally should not be less than
[A]
2
[B]
3
[C]
5
[D]
No limit
(6)
The service area in a building means the area occupied by
[A]
Stairs
[B]
Toilets
[C]
Light and shafts
[D]
All the above
(7)
Open test pit is only suitable upto a depth of
[A]
2 metres
[B]
2.5 metres
[C]
3 metres
[D]
None of the above
(8)
For different layers of cement concrete floor. Pick up the incorrect statement from the following:
[A]
The lowest layer consists of consolidated ground
[B]
A 10 cm thick clean sand is laid on consolidated ground
[C]
A 10 cm lime concrete (1 : 4 : 8) is laid on clean sand
[D]
A 10 cm thick cement concrete (1 : 2 : 4) is laid on top layer
Answer: A 10 cm thick cement concrete (1 : 2 : 4) is laid on top layer
(9)
A wall constructed with stones to protect slopes of cuttings in natural ground from the action of weathering agents, is called
[A]
Retaining wall
[B]
Breast wall
[C]
Buttress
[D]
Parapet wall
(10)
Pick up the correct statement from the following:
[A]
D.P.C. should be continuous
[B]
D.P.C. should be of good impervious material
[C]
D.P.C. may be horizontal or vertical
[D]
All the above
(11)
The inclined surface of an abutment to receive the arch, is known as
[A]
Skew back
[B]
Soffit
[C]
Spandril
[D]
Haunch
(12)
The type of roof which slopes in two directions with a break in the slope on each side is known as
[A]
Gable roof
[B]
Hip roof
[C]
Gambrel roof
[D]
Mansard roof
(13)
Pick up the correct statement from the following:
[A]
A mortar joint having a concave finishing in brick masonry, is called keyed joint
[B]
A mortar joint projecting beyond the face of a masonry wall, is called tucked joint
[C]
A mortar joint having a recess in it, is called ruled joint
[D]
All the above
(14)
The pile which supports the load due to friction between pile face and surrounding soil, is generally known as
[A]
Bearing pile
[B]
Friction pile
[C]
Sheet pile
[D]
Battered pile
(15)
The platform at the end of a series of steps, is known as
[A]
Platform
[B]
Relief
[C]
Rest
[D]
Landing
(16)
The type of arch generally constructed over a wooden lintel or over a flat arch for the purpose of carrying the load of the wall above is
[A]
Segmental arch
[B]
Pointed arch
[C]
Relieving arch
[D]
Flat arch
(17)
The process of filling hollow spaces of walls before plastering, is known
[A]
Hacking
[B]
Dubbing out
[C]
Blistering
[D]
Peeling
(18)
The form work from the slabs excluding props, can be removed only after
[A]
1 day
[B]
4 days
[C]
7 days
[D]
14 days
(19)
Cast iron piles
[A]
Are suitable for works under sea water
[B]
Resist shocks or vibrations
[C]
Are suitable for use as batter piles
[D]
Are useful for heavy vertical loads
Answer: Are useful for heavy vertical loads
(20)
To obtain good bonding in brick masonry
[A]
First class bricks are used
[B]
Vertical joints in alternate courses are kept in plumb line
[C]
Bats are used where necessary
[D]
All the above
Please share this page