GkSeries.com

Electric Circuits MCQs | Electric Circuits MCQs & Answers for competitive exams

81 If a conductor is put in a magnetic field, at what angle the conductor should cut the magnetic field to induce maximum current in it ?
[A] 10°
[B] 20°
[C] 90°
[D] 120°
Answer: 90°
82 Which of the following expression is true for apparent power in an AC circuit ?
[A] Vr.m.s.×Ir.m.s.
[B] Vmean×Imean
[C] Vpeak×Ipeak
[D] V I cos⁡ϕ
Answer: Vr.m.s.×Ir.m.s.

DOWNLOAD CURRENT AFFAIRS PDF FROM APP

83 The power dissipation in the pure capacitance of RC circuit will be
[A] Zero
[B] Small
[C] Higher than dissipation in resistance
[D] Equal to dissipation in resistance
Answer: Zero
84 Which of the following expression is correct for series reactance Xcs if three capacitors C1, C2 and C3 are connected in series?
[A] 1/Xcs = 1/Xc1 + 1/Xc2 + 1/Xc3
[B] Xcs = Xc1 + Xc2 + Xc3
[C] Xcs = 1/Xc1 + 1/Xc2 + 1/Xc3
[D] Xcs = 1/Xc1 + Xc2+ Xc3
Answer: Xcs = Xc1 + Xc2 + Xc3
85 An peak value of the sinusoidal voltage is 10 volts. What will be the effective of voltage ?
[A] 14.14 volts
[B] 1.414 volts
[C] 0.707 volts
[D] 7.07 volts
Answer: 7.07 volts
86 An inductance coil of 10 H develops the counter voltage of 50 volts. What should be the rate change of current in the coil ?
[A] 5 A/sec
[B] 10 A/sec
[C] 1 A/sec
[D] 100 A/sec
Answer: 5 A/sec
87 The voltage source of 220 V shown in the figure will deliver the total current to the circuit of
[A] 4 A
[B] 2 A
[C] 50 A
[D] 100 A
Answer: 50 A
88 The four bulbs of 40 watts each are connected in series with a battery across them, which of the following statements is true?
[A] The voltage across each bulb is same
[B] The power dissipation in each bulb is not same
[C] The current through each bulb is same
[D] None of the above
Answer: The current through each bulb is same
89 The current in the loaded battery flows from
[A] + ve to – ve plate
[B] – ve to + ve plate
[C] Between plates
[D] Between terminals
Answer: – ve to + ve plate
90 In the given circuit, the Kirchhoff’s current law at the point A is applied. Which of the following relation is correct
[A] I1 = I2- I3
[B] I1 - I3+ I3=0
[C] I1- (I2+ I3 )=0
[D] I1= -(I2+ I3 )
Answer: I1- (I2+ I3 )=0
91 If the diameter of a current carrying conductor is doubled, the resistance will
[A] Be reduced to half
[B] To reduced to one-fourth
[C] Remain same
[D] Be doubled
Answer: To reduced to one-fourth
92 The quality factor of RCL circuit will increase if the
[A] R decreases
[B] R increases
[C] Voltage increases
[D] Impedance increases
Answer: R decreases
93 The power factor of a purely resistive circuit will be
[A] unity
[B] zero
[C] infinity
[D] 0.5
Answer: unity
94 Which of the following operations is to be carried on to get ramp function from unit impulse at t = 0 ?
[A] integrate unit impulse function once
[B] integrate unit impulse function twice
[C] integrate unit impulse function thrice
[D] differentiate unit impulse function twice
Answer: integrate unit impulse function thrice
95 For which of the following function the Laplace will be 2/s2
[A] ƒ(t) = t
[B] ƒ(t) = 1
[C] ƒ(t) = δt
[D] ƒ(t) = t2
Answer: ƒ(t) = t2
96 Which of the following function represents parabolic characteristics?
[A] ƒ(t) = t
[B] ƒ(t) = t2
[C] ƒ(t) = e-at
[D] ƒ(t) = Ut
Answer: ƒ(t) = t2
97 A pure inductance is connected with DC source as shown. The inductance will behave as
[A] Open circuit
[B] Closed circuit
[C] Short circuit
[D] None of the above
Answer: Short circuit
98 A voltage divider and its Thevenin’s equivalent circuit is shown below. What will be the value of voltage source V and resistance R.
[A] 10 V, 80 Ω
[B] 10 V, 120 Ω
[C] 4 V, 48 Ω
[D] 5 V, 50 Ω
Answer: 4 V, 48 Ω
99 In the circuit shown below, what will be the voltage uR at t = 0?
[A] 0
[B] V
[C] V/2
[D] 0.37 V
Answer: V
100 In the figure of Q. 188, what will be the voltage uR at t = ∞?
[A] 0
[B] V
[C] 0.37 V
[D] 0.63 V
Answer: 0

Please share this page

Click Here to Read more questions

Teacher Eligibility Test