Computer Hardware MCQs

Which part of the laser printer should NOT be exposed to sunlight?

April 12, 2022

10 Views

Which part of the laser printer should NOT be exposed to sunlight?

Q. Which part of the laser printer should NOT be exposed to sunlight?

A. Transfer corona assembly

B. Primary corona wire

C. PC drum

D. Toner cartridge

Answer: PC drum

Which part of the laser printer should NOT be exposed to sunlight?

Previous

On the 16-bit ISA bus, IRQ2 is elevated to which higher level Interrupt?

Which part of the laser printer should NOT be exposed to sunlight?

Next

After doing a low-level format, what would be the next step in configuring the hard drive in a system?

Related Articles

The monitor power LED is „on‟ but the monitor screen is completely dark

The monitor power LED is “on‟ but the monitor screen is completely dark. The least likely cause of the problem is:

Dust in a computer actually increase the size of the magnetic fields inside it. This is not good, so you must occasionaly dust, I trust. What‟s the best way to do this?

Dust in a computer actually increase the size of the magnetic fields inside it. This is not good, so you must occasionaly dust, I trust. What‟s the best way to do this?

A parity error usually indicates a problem with

A parity error usually indicates a problem with

What is the size of the reserved memory area?

What is the size of the reserved memory area?

We will be happy to hear your thoughts

Leave a reply Cancel reply