Microwave Communication General Knowledge Quiz | Microwave Communication General Knowledge Objective Type Questions & Answers

Sports GK Questions and Answers 2024 (Latest Updated)

Awards & Honours GK Questions 2024 (Latest Updated)

Questions
21 As the electron beam moves through a klystron’s intercavity drift space
A Frequency modulation at the input cavity creates velocity modulation at the output cavity
B Velocity modulation at the input cavity creates density modulation at the output cavity
C Density modulation at the input cavity creates velocity modulation at the output cavity
D Phase modulation at the input cavity creates velocity modulation at the output cavity.

Answer: Velocity modulation at the input cavity creates density modulation at the output cavity
22 The frequency of the oscillation generated by a magnetron, is mainly determined by
A The flux density of the external magnet
B The ratio of the dc cathode voltage to the magnetic flux density
C The number of the cavity resonators
D The dimension of each cavity resonator

Answer: The dimension of each cavity resonator
Advertisement
Article and Schedule Quiz Start Test!
DOWNLOAD CURRENT AFFAIRS PDF FROM APP
23 If the instantaneous RF potentials on the two sides of a magnetron cavity are of opposite polarity, the operation is in the
A π mode
B π/2 mode
C 2π mode
D π/4 mode

Answer: π mode
24 The Gunn diode oscillator
A Depends on the formation of charge domain
B Operates over a positive resistance characteristic
C Is capable of generating continuous microwave power of the order of kilowatt
D Generates frequencies which are below 100 MHz

Answer: Depends on the formation of charge domain
25 What ferrite device can be used instead of duplexer of isolate microwave transmitter and receiver when both are connected to the same antenna?
A Isolator
B Magnetron
C Simplex
D Circulator

Answer: Circulator
26 To achieve good bearing resolution when using a pulsed-radar set, an important requirement is
A A narrow, antenna-beam width in the vertical plane
B A narrow, antenna-beam width in the horizontal plane
C A low repetition rate
D A high duty cycle

Answer: A narrow, antenna-beam width in the horizontal plane
27 When used in conjunction with a radar set, the purpose of an echo box is to provide an artificial target.
A Which may be used to tune the radar synchronizer
B Which may be used to tune the radar receiver
C To the tone of the pulse repetition
D Tune the magnetron to the correct frequency

Answer: Which may be used to tune the radar receiver
28 In a radar-set receiver, the usual mixer stage is
A And FET
B A tunnel diode
C A silicon crystal
D A Rochelle salts crystal

Answer: A silicon crystal
29 Klystron oscillators are most often used in the frequency range of
A 300 to 3000 MHz
B 3000 to 30000 MHz
C 30 to 30000 MHz
D 10 to 10000 MHz

Answer: 3000 to 30000 MHz
30 Oscillators of a klystron tube are maintained
A By bunches of electrons passing the cavity grids
B By plate-to-cathode feedback
C By feedback between the accelerating grid and the repeller
D By circulating bunches of electrons within the cavities.

Answer: By bunches of electrons passing the cavity grids
31 What allow microwave to pass in only one direction?
A RF emitter
B Capacitor
C Varactor-triac
D Ferrite emitter

Answer: Ferrite emitter
32 In an SHF pulsed radar set, a reflex klystron can be used as a
A Single mixer stage
B Local oscillator
C Transmitter oscillator
D Duplexer stage

Answer: Local oscillator
33 A Class-S Emergency Position-Indicating Radio Beacon (E.P.I.R.B)
A Must be capable of floating or being secured to a survival
B Must have its battery replaced after emergency use
C May be tested during the first five minutes of any hour
D All of these

Answer: All of these
34 A PPI cathode-ray tube as used on a radar set
A Is used to check the percentage of modulation
B Indicates both the range and azimuth of a target
C Indicates only the range of a target
D Is used for receiver alignment

Answer: Is used for receiver alignment
35 The resonant frequency of a cavity resonator depends upon
A The mode of operation
B Its electrical dimensions
C Its physical dimensions
D The capacitor which tunes it

Answer: Its physical dimensions
36 The maximum usable range of the usual radar set (on any particular range setting) is determined by
A The width of the transmitted pulses
B The interval between transmitted pulses
C The bandwidth of the receiver IF stages
D The duty cycle

Answer: The interval between transmitted pulses
37 A reflex klystron is oscillating at the frequency of its resonant cavity. If the reflector voltage is made slightly less negative, the
A Oscillation will cease
B Output power would increase
C The frequency will decrease
D Bunching would occur earlier in time

Answer: The frequency will decrease
38 The coarse frequency adjustment of a reflex klystron is accomplished by
A The AFC system
B Adjusting the flexible wall of the resonant cavity
C An adjustment in the synchronizer
D Varying the repeller voltage

Answer: Adjusting the flexible wall of the resonant cavity
39 In a pulsed radar set, the STC circuit is used to
A Improve the target bearing resolution
B Increases receiver sensitivity for echoes from targets
C Vary the pulse frequency in order to control the maximum target
D Reduce interference from the effects of sea return

Answer: Reduce interference from the effects of sea return
40 In a pulsed radar set, the function of the duplexer is to
A Aid in calibrating the display unit
B Prevent frequency drift in the klystron
C Allow the transmitter and the receiver to operate from a common antenna
D All of these

Answer: Allow the transmitter and the receiver to operate from a common antenna

Random GK Questions

Assam Direct Recruitment Test Series

Teacher Eligibility Test

Assam Direct Recruitment Test Series