Download PDF
Free download in PDF Gearbox Short Questions and Answers for competitive exams. These short objective type questions with answers are very important for Board exams as well as competitive exams. These short solved questions or quizzes are provided by Gkseries.
41
When shifting into low, a gear on the transmission main shaft is moved in to mesh with the
[A]
Counter shaft low gear
[B]
Counter shaft idler
[C]
Clutch gear
[D]
Output gear
Answer: Counter shaft low gear
42
Synchronizing is designed to prevent gear clash when shifting into
[A]
First and reverse
[B]
First and second
[C]
Second and high
[D]
All above
43
On diaphragm spring clutch, pressing down on the clutch pedal moves throw out bearing in against the
[A]
Release levers
[B]
Diaphragm
[C]
Pressure plate
[D]
Friction disc
44
The device that produces different gear ratios in the power train is called
[A]
Differential
[B]
Transmission
[C]
Speed Changer
[D]
None of the above
45
In transmission reduction of speed is always used to obtain
[A]
Reduction of torque
[B]
Constant torque to drive the wheels
[C]
Increase of torque
[D]
All of the above
Answer: Increase of torque
46
The conventional motor car has
[A]
Two forward speeds
[B]
Three forward speeds
[C]
Four forward speeds
[D]
All above
Answer: Four forward speeds
47
The second movement of the gear shift lever produces
[A]
The correct gears to mesh
[B]
The movement of the drive gear
[C]
Release of clutch
[D]
None Of The Above
Answer: The correct gears to mesh
48
The synchronizing device used in the transmission uses
[A]
Cone braking surfaces
[B]
Flat braking surfaces
[C]
Synchronizing pins
[D]
Epicyclical gearbox
Answer: Cone braking surfaces
49
The overdrive is located between
[A]
Gear box and clutch
[B]
Gear box and propeller shaft
[C]
Planetary gears and clutch
[D]
None of these
Answer: Gear box and propeller shaft
50
Transmission noise in neutral could result from
[A]
Worn gears
[B]
Loose propeller shaft
[C]
two turns
[D]
Misadjusted gear linkage
Please share this page