Download PDF
Free download in PDF Estimation and Costing Objective Type Questions and Answers for competitive exams. These short objective type questions with answers are very important for Board exams as well as competitive exams. These short solved questions or quizzes are provided by Gkseries.
(21)
For 100 sq. m cement concrete (1 : 2: 4) 4 cm thick floor, the quantity of cement required, is
[A]
0.94 m3
[B]
1.00 m3
[C]
0.98 m3
[D]
0.90 m3
(22)
Size, capacity and materials need be specified for
[A]
Ball valves
[B]
Bib-cocks
[C]
Stop-cocks
[D]
All the above
(23)
Berms are provided in canals if these are
[A]
Partly in excavation and partly in embankment
[B]
Fully in embankment
[C]
Fully in excavation
[D]
All the above
Answer: Partly in excavation and partly in embankment
(24)
The rate of payment is made for 100 cu m (per % cu m) in case of
[A]
Excavation in trenches for foundation
[B]
Earth work in excavation
[C]
Rock cutting
[D]
All the above
(25)
The main factor to be considered while preparing a detailed estimate, is
[A]
Quantity of the materials
[B]
Availability of materials
[C]
Transportation of materials
[D]
All the above
(26)
If the formation level of a highway has a uniform gradient for a particular length, and the ground is also having a longitudinal slope, the earthwork may be calculated by
[A]
Prismoidal formula
[B]
Mid-section formula
[C]
Trapezoidal formula
[D]
All the above
(27)
While estimating the qualities for the construction of a building, the correct metric unit is
[A]
Litre for capacity
[B]
Square metres for volume
[C]
Cubic metre for area
[D]
None of these
Answer: Litre for capacity
(28)
In the mid-section formula
[A]
The volume of the earth work is calculated by multiplying the mid-section area by the distance between the two original sections
[B]
The area of mid-sections is calculated by using mean depth
[C]
The mean depth is the average of depths of two consecutive sections
[D]
All of the above
(29)
Referring of given figure, pick up the correct statement from the following:
[A]
Length of short walls in-to-in is 3.20 m
[B]
The total length of centre line of four walls is 20 m
[C]
Length of long wall out-to -out is 6.80 m
[D]
All the above
(30)
According to Indian Standards Institute, the actual size of modular bricks is
[A]
19 cm × 9 cm × 9 cm
[B]
20 cm × 10 cm × 10 cm
[C]
25 cm × 13 cm × 7.5 cm
[D]
23 cm × 11.5 cm × 7.5 cm
Answer: 19 cm × 9 cm × 9 cm
31
The following item of earth work is not measured separately.
[A]
Steps in deep excavation
[B]
Site clearance
[C]
Setting out of works
[D]
All the above
32
The measurement is made in square metre in case of
[A]
Hollow concrete block wall
[B]
R.C.C. structure
[C]
Cement concrete in foundation
[D]
None of these
33
Cost of fittings and their fixing is specified for the following sanitary fittings
[A]
Lavatory basins
[B]
Flushing pipes
[C]
Water closets
[D]
All the above
34
Pick up the correct statement from the following:
[A]
Glazing is measured in sq.m
[B]
Plastering is measured in sq.m
[C]
Pointing is measured in sq.m
[D]
All the above
35
The value of ‘B’ of Indian type W.C. shown in the given figure is:
[A]
30 cm
[B]
50 cm
[C]
45 cm
[D]
None
36
Pick up the excavation where measurements are made in square metres for payment.
[A]
Ordinary cuttings up to 1 m
[B]
Surface dressing up to 15 cm depths
[C]
Surface excavation up to 30 cm depths
[D]
Both B. and C.
37
In long and short wall method of estimation, the length of long wall is the centre to centre distance between the walls and
[A]
Half breadth of wall on each side
[B]
One fourth breadth of wall on each side
[C]
Breadth of the wall
[D]
None of these
Answer: Half breadth of wall on each side
38
The measurement is not made in square metres in case of
[A]
R.C. Chhajja
[B]
D.P.C. (Damp proof course)
[C]
Concrete Jeffries
[D]
Form works
39
The trap which is provided to disconnect the house drain from the street sewer is called
[A]
Interception manhole
[B]
Intercepting trap
[C]
Master trap
[D]
All the above
40
While preparing a detailed estimate
[A]
Volume should be measured correct to 0.01 cum
[B]
Area should be measured correct to 0.01 sqm
[C]
Dimension should be measured correct to 0.01 m
[D]
All the above
Please share this page